SuperMicro SYS-2026TT-H6RF 4Node server 8x Quad-Core X5570 2.93GHz 192G 24x300GB

Product Brand: SuperMicro
Product Condition: Used
Excluding VAT: £4,750.00
Including VAT: £5,700.00
Information

SuperMicro SYS-2026TT-H6RF 4Node server 8 x Quad-Core X5570 2.93GHz 192GB 24 x 300GB

In very good condition, tested


 

Included

  • 1 x Supermicro SuperServer SYS-2026TT-H6RF 4 NODE 2U Chassis
  • 8 x Intel QUAD-CORE XEON X5570 2.93GHz 8M Cache processors
  • 192GB Ram
  • 24 x 300GB 10K 2.5" hot plug hard drives
Full spec
Product SKUs
SYS-2026TT-H6RF
  • SuperServer 2026TT-H6RF (Black)
Motherboard

4x Super X8DTT-HEF+
Processor/Cache
CPU
  • Dual 1366-pin LGA Sockets
  • Supports up to two Intel® 64-bit Xeon®processor(s) of the same type below:
    • Intel® Xeon® Processor X5600/E5600/L5600 Series
      (Westmere) 40W - 95W
    • Intel® Xeon® Processor X5500/E5500/L5500 Series
      (Nehalem-EP) 38W - 95W
QPI
  • up to 6.4 GT/s
System Memory
Memory Capacity
  • 12x 240-pin DIMM sockets
  • Supports up to 192 GB** 1333 / 1066 / 800MHz DDR3 ECC Registered memory
  • Supports up to 48 GB 1333 / 1066 / 800MHz DDR3 ECC / Non ECC Unbuffered memory
  • Memory Mirroring supported
Memory Type
  • 1333 / 1066 / 800MHz ECC Registered / ECC or Non ECC Unbuffered DDR3 SDRAM 72-bit, 240-pin gold-plated DIMMs
DIMM Sizes
  • 1GB, 2GB, 4GB , 8GB** , 16GB**
Memory Voltage
  • 1.5 V
Error Detection
  • Corrects single-bit errors
  • Detects double-bit errors (using ECC memory)
  • Supports Intel® x4 and x8 Single Device Data Correction (SDDC)
On-Board Devices (per Node)
Chipset
  • Intel® 5520 (Tylersburg) chipset
  • ICH10R + IOH-36D
SATA
  • Intel ICH10R SATA 3.0Gbps Controller
  • RAID 0, 1, 5, 10 support
SAS
  • LSI 6Gbps SAS 2108 w/ Hardware RAID support via BPN-ADP-SAS2-H6iR
  • RAID 0, 1, 10, 5, 50, and 6 support
IPMI
  • Support for Intelligent Platform Management Interface v.2.0
  • IPMI 2.0 with virtual media over LAN and KVM-over-LAN support
  • Nuvoton WPCM450 BMC
Network Controllers
  • Dual Intel® 82574L Gigabit Ethernet Controller
  • Supports 10BASE-T, 100BASE-TX, and 1000BASE-T, RJ45 output
  • 1x Realtek RTL8201N PHY (dedicated IPMI)
Graphics
  • Matrox G200eW
Super I/O
  • Winbond W83527HG chip
Clock Generator
  • 932S421 chip
Input / Output (per Node)
Serial ATA
  • Six Serial ATA ports
  • 6 SATA hard drives supported
LAN
  • 2x RJ45 LAN ports
  • 1x RJ45 Dedicated IPMI LAN port
USB
  • 2 rear + 1 header (2 Ports)
  • 4 total USB ports, 2.0 Compliant / 1.1 Compliant
VGA
  • 1x VGA Port
Serial Port
  • 1 Fast UART 16550 serial port
System BIOS (per Node)
BIOS Type
  • 32Mb SPI Flash EEPROM with AMI® BIOS
BIOS Features
  • Plug and Play (PnP)
  • PCI 2.2
  • ACPI up to 3.0
  • USB Keyboard support
Chassis
Form Factor
  • 2U Rackmount
Model
Dimensions
Height 3.47" (88mm)
Width 17.25" (438mm)
Depth 26.75" (679mm)
Gross Weight 85 lbs (38.6kg)
Available Colors Black
Front Panel (per Node)
Buttons
  • Power On/Off button
  • UID button
LEDs
  • Power LED (on power button)
  • Network activity LED
  • System Overheat/fan fail/power fail/ LED
  • UID LED (on UID button)
Expansion Slots (per Node)
PCI-Express
  • 1 (x16) PCI-E 2.0 (Low Profile)
Drive Bays (per Node)
Hot-swap
  • 6x 2.5" hot-swap drive bays
Hard drive Backplane
2U Hard drive Backplane
System Cooling
Fans
  • 4x Cooling Fans
Power Supply
1400W high-efficiency (1+1) redundant power supply with PMBus
AC Input
  • 1100W Output @ 100-140V, 13.5-9.5A, 50-60Hz
  • 1400W Output @ 180-240V, 9.5-7.0A, 50-60Hz
DC Output
  • 1100W: +12V/92A; +5Vsb/4A
  • 1400W: +12V/116A; +5Vsb/4A
With Distributor
  • +5V: 30 Amp
  • +3.3V: 24 Amp
  • -12V: 0.6 Amp
Certification Gold Level Certified
Gold Certified
[ Test Report ]
PC Health Monitoring
CPU
  • Monitors for CPU Cores,+1.5V, +3.3V, +5V, +12V, +5 Stdby, +3.3 Stdby, VBAT, Memory Voltages.
  • CPU Core 6-Phase-switching voltage regulator
FAN
  • Total of four 4-pin PWM fans
  • 4x fans with tachometer monitoring
  • Status monitor for speed control
  • Status monitor for on/off control
  • Low noise fan speed control
Temperature
  • Monitoring for CPU and chassis environment
  • CPU thermal trip support
  • Thermal Control for 4x Fan Connectors
  • PSU I2C temperature sensing logic
  • Thermal Monitor 2 (TM2) support
  • PECI
LED
  • Power Fail / Overheat LED
  • Suspend-state Indicator LED
  • UID LED
Other Features
  • SDDC Support
Operating Environment / Compliance
RoHS
  • RoHS Compliant
Environmental Spec.
  • Operating Temperature: 10°to 35°C (50°to 95°F)
  • Non-operating Temperature: -40°to 70°C (-40°to 158°F)
  • Operating Relative Humidity: 8% to 90% (non-condensing)
  • Non-operating Relative Humidity: 5 to 95% (non-condensing)

We can supply this server with a different specification to suit your requirements; more or less memory, different or additional hard drives, additional network cards etc. Please contact us for a quote.

DELIVERY IS WITH UPS

Any Questions? Please call 020 8882 1111 from UK or +44 208882 1111 from outside the UK

8903 - 84133 84134 84135 84136 84137

To request a price please fill out the form below...


Close